1. Custom Solutions
  2. Radar & EW Products
  3. Threat Controller

Threat Controller

The FPGA Based Threat Controller Card is used for upgrade of the Multi-Emitter Simulator. The hardware architecture is based on Zynq Ultra scale device which as in built processor and FPGA resources with enough block RAMs for the dynamic simulation requirement along with all the requisite interface and memory requirements

FPGA Based Threat Controller Card

Features

  • Zynq Ultra scale FPGA
  • 10/100/1000 base-T Ethernet Interface
  • 200 MHz On board clock
  • MIL1553B Interface
  • Dual QSPI flash
  • USB3.0/USB2.0
  • SD Card Slot
  • Signal Integrity, Power Integrity and Thermal Analysis
  • PCI Express interface routed to VPX connectors
  • 6U VPX Form Factor
  • 28 V DC power Input

Specifications

Processor Zynq Ultrascale
Clock Source 100 MHz, 33.33 MHz
RAM DDR4, DDR3, DDR3L
Other Memories eMMC 4.51 Managed NAND flash, serial NOR flash, SD CARD
Interfaces PCI Express Compliant with PCIe® 2.1; SATA
Transceivers 4x PS-GTR up to 6.0 Gb/s
Other Interfaces USB 3.0
Standard Interfaces MIL-1553, SGMII tri-speed Ethernet
Power Supply 28 V Input